Your are viewing a read-only archive of the old DiS boards. Please hit the Community button above to engage with the DiS !
I want to make a pedal board out of wood
I thought this was the 'knocking one out at work' thread.
I can get you some wood from work, if you're happy with resin reinforced ply. What would you want, 1' by 2', or more like 6" by 2'?
Do you have a saw?
But I can use the band saw or circular saw at work if you give me the dimensions.
I can even do a rimjob for you, dog
I'll get designing. Would be good to start from skratch, I could royally mess up your garden! How come you've got wood?
We have loads of sheet, block and cylinder metal/plastic, and a whole bunch of wood. We use it quite a bit for legboards on wheelchairs.
there's always spares going that we chuck out, a lot of stuff can only be used for one patient, so it comes back but we can't reuse for another patient.
back to your measurements, where the options either 1 inch by 2 inches or 6 inches by 2 inches?
Anything up to 2ft in either direction is fine. Can do a wedge (so it's on a slope) as well if you want.
Or we can just go into work the next time you're about these here parts
2 feet should be just about ok I think
just have a nice walk around your area and twonk some wood from a skip!
but twonk? that'd means div innit.